Share your Expertise

Hello, i wanted to ask if someone else had problem with replacing a member of a virtual-chassis from MIST, our customer had a problem on the FPC0 member so we replaced it, the procedure i followed ...

Hi all, I'm trying to configure DHCP server pool in a vSRX in packet mode inside a routing-instance, but doesn't seem to be working . The dhcp pool in the global routing table works fine but the ...

This is the final post in the #JumpstartJSI series. Special thanks to @Devin and @pgoddard for their contributions. Below is a quick overview of the series: Why Connect to JSI Juniper Support ...

Hi all, An EVE-NG VM was recently migrated to EVE-NG bare metal and since the migration the Junos images have stopped booting. I have focused on the vSRX image as its more urgent The server has plenty ...

I used to configure in the following ways: provider-tunnel ldp-p2mp provider-tunnel rsvp-te label-switched-path-template default-template Anyone can tell me what are the differences if conigured ...

I am unable to ping both layer two switches or devices at same time from 2 mx480 from both ends. I can configure 1 native VLAN , unable to configure two native vlans in the port connecting these devices. ...

LABSTACK-4100> show log messages | match ge-2/0/21 Jul 19 11:03:57 LABSTACK-4100 fpc2 ifd ge-2/0/21; Ether get info vector error (100) Was checking logs earlier monitoring port flaps and troubleshooting ...

Hello I have MX240LNS support PPPoE on the subinterface but the problem that juniper don't support using a different MAC addresses defined on aggregated ethernet logical interfaces ...

Hello I have MX240LNS support PPPoE on the subinterface but the problem that juniper don't support using a different MAC addresses defined on aggregated ethernet logical interfaces ...

Privacy and security are always top of mind when managing your network. Protecting our customers' data is mission-critical to Juniper. Read the Juniper Support Insights Security and Privacy Overview ...

i have 11 racks , each rack is virtual chassis and one rack is the core (also virtual chassis) , all 11 rack is connected to the core by aggregation link (trunk with vlan member all ) on all racks , i ...

Hello, I have SRX 220H2 and fortigat 120G , I made IPSEC vpn between both and the tunnel is up after matching the configuration between SRX and fortigate But when I tried to ping and ip address ...

Trying to setup a test between Juniper EX and Cisco ASR. This is a point to point link, where each device has the interface inside a VRF. I can ping when the Juniper interface is not in a routing-instance. ...

We are back with more #JumpstartJSI this week. I hope everyone is enjoying the summer holidays and/or mid-year break. As briefly mentioned in the Jumpstart JSI Week 5 post , there are three ways ...

Hello, I'm trying to use " Delegated-ipv6-Prefix" from radius to give a /56 to my CPE with these configurations: Delegated-ipv6-Prefix dont seem to be present in this link: https://www.juniper.net/documentation/us/en/software/junos/subscriber-mgmt-getting-started/topics/topic-map/dynamic-profiles-predefined-variables.html ...

There won't be a #JumpstartJSI post this week due to the Fourth of July (US) and the Canada Day holidays. You can still learn more by watching the recording from last week's Jumpstart JSI Ask the ...

On newer 23.4 code, you can send Type 5 routes via evpn signaling. I can ping 192.168.50.1 from the vEX to the vSRX, but not 192.168.60.1 from the SRX to the vEX. However, traceroute does work from ...

hello everyone. i have a strange problem on an MX240 with MPC 3D 16x 10GE. this router run full internet table feed and 1 IXP with remote EVPN customer that share IXP port remotely. i know for ...

This week’s #JumpstartJSI post arrives a day early because, @Devin , @Ahmed Khalil , and me are hosting TWO Ask the Expert meet-up sessions to explore JSI. These meetups are the perfect opportunities ...

Hello. I have a cluster pair of SRX1500s. Receiving repetitive spam of Detected Tx Unit Hang: igb 0000:07:00.2: Detected Tx Unit Hang Tx Queue <0> TDH<44> TDT<46> ...